Medical Air System Replacement

Phase 1

• Plan, review and coordinate (N) MGA-signal wire conduit route from (N) medical vacuum system. Complete all conduits
  and wiring to a terminal box in the mechanical room. ICRA planning and coordination. (2) (E) Master Alarm Panel
  locations including security office.
• Coordinate and complete demo/removal of (E) HE-5 and HE-6. *Including review of steam piping distribution system.
• Complete (N) concrete equipment pad.
• Install temporary medical air system equipment. Including plumbing, electrical, and structural installation requirements.
  Current plan is to install temporary medical air system on existing concrete equipment pads.

Phase 2

• Receive set and seismically anchor (N) AES-Powerex triplex 40HP oil-less scroll medical air compressor system model
  AES-MSET40-SPL with variable pump demand.
• (N) Powerex Oil-Less Scroll air compressors.
• Proposed Triplex 40HP Powerex.
• System Capacity 294.4 ICFM @ 50 PSIG with (1) 40HP Enclosed Scroll in Reserve. *System Capacity 368
  ICFM @ 50 PSIG with one 20HP module compressor in reserve per NFPA99.
• 25% to 56% increase in system capacity.
• Confirm height dimension of structural steel pipe supports and stands as required.
• Install structural steel pipe support and stands as required.
• Complete (N) medical air system plumbing POC for medical air intake (E) 3” and medical air discharge (E) 2”. Coordinate
  medical air system installation verification/certification.
• Complete interconnecting system wiring.

Medical Vacuum System Replacement

Phase 1

• Plan, review and coordinate (N) MGA-signal wire conduit route from (N) medical vacuum system. Complete all conduits
  and wiring to a terminal box in the mechanical room. ICRA planning and coordination. (2) (E) Master Alarm Panel
  locations including security office.

Phase 2

• Receive set and seismically anchor (N) AES-Powerex Quad 15HP oil-less rotary claw medical vacuum system model
  CVPQ1505 with VFD controls and manifold piping. System Capacity 387 SCFM @19″HGVAC with one pump reserve per NFPA99.  *Note 129 SCFM @19″HGVAC each vacuum pump.
• Confirm height dimension of structural steel pipe supports and stands as required.
• Install structural steel pipe support and stands as required.
• Complete (N) medical vacuum system plumbing POC for exhaust/discharge (E) 4” and suction (E) 4”. *Provide temporary/emergency suction and exhaust POC valves.
• Coordinate medical air system installation verification/certification.
• Complete interconnecting system wiring.
• Complete main power feed.
• Startup and test (N) medical vacuum system.
• Coordinate final medical gas system certification.

Phase 3

• Demo and remove (E) medical vacuum system.
• OSHPD Closeout

AES Group looks forward to our next opportunity, to work with you and your team,  providing medical and laboratory vacuum system solutions.