(N) Medical Air Dryer Installation:

• Provide and Install (N) Medical Air Dryer including:
  • (1) (N) BeaconMedaes Duplex Desiccant Medical Air Dryer Model:LDD055D-DR Lifeline Dryer
    • BeaconMedaes P/N 410700652
    • 55 CFM with Dewpoint Monitor for Purge Control, NO CO Monitor (E) to Remain
    • Single Point Connections
    • Pre-piped and Wired Dewpoint Sensor with Remote Contacts
    • Duplex Drying System with Purge Controlled Desiccant Dryers with Mounted Prefilters, Afterfilters, Regulators, Isolation Valves to Permit Uninterrupted PM Service, Safety Relief Valves and Air Sample Port.
  • Rigging Temporary Equipment.
    • Seismic Anchorage per Structural Details
    • Provide and Install (N) 3/8”x1’-6”x2’ ASTM A572 GR 50 Steel Plate per Structural Details S1
      • Paint to Match Existing
    • Plan and Schedule Medical Air System Shutdown with Engineering and CMT. MOP Required.
    • Electrical:
      • (N) Medical Air Dryer Power Fed from Panel EXPH per Drawing E0
        • Disconnect (E) Temporary Medical Air Dryer and Reconnect (N) Medical Air Dryer “Use Appliance Cords Furnished with Equipment”. (N) Conduit and Wire as Required
      • Medical Gas Alarm Signal Wire and Conduit as Required.
    • Plumbing:
      • (N) Medical Air Dryer POC.
        • ¾” Temporary Medical Air System Interconnecting Piping between (E) ¾” Receiver Inlet POC to (N) Temporary Medical Air Dryer.
        • ¾” Temporary Medical Air Dryer Discharge POC to (E) Receiver.
        • ½” Drain Line
        • Reroute (E) 2” MA Piping and Flex Connector
      • Startup (AES) and System Certification provided by CMT.

To see more or our completed projects visit our Projects Page.